What SpanDraft calculates – and what it does not
SpanDraft analyzes a straight beam in a two-dimensional bending plane.
The material and cross-section are constant within a segment and change abruptly at the segment boundaries, supports are idealized, and deformations are assumed to be small.
The calculation is based on the linear-elastic Euler–Bernoulli beam model.
What the model represents
| Area | Assumption in SpanDraft |
|---|---|
| Beam | one straight beam |
| Material | constant and linear elastic within each segment |
| Cross-section | constant within each segment, with one selected bending axis per segment |
| Deformation | small displacements and rotations |
| Supports | ideal Fixed, Pinned, or Roller Supports |
| Loads | vertical point forces, point moments, constant and linearly varying distributed loads, and optional self-weight |
| Results | deformation, shear force, bending moment, support reactions, and a basic bending assessment |
When the model is a good fit
SpanDraft is particularly suitable for slender beams where bending dominates and shear deformation is comparatively small.
For very short or deep beams, shear deformation may become significant; it is not included in the model.
If the deformations are large enough to significantly change the geometry or the effect of the loads, the linear model is no longer sufficient.
What is not included
Three-dimensional loading
Inclined forces or forces with arbitrary directions in space, simultaneous bending about two axes, and torsion are not included.
SpanDraft does not perform a general three-dimensional structural analysis.
Extended loads and supports
Self-weight can be included as a downward constant distributed load derived from the material density and cross-sectional area.
Distributed loads are constant or linearly varying; nonlinear intensity profiles and external axial loads are not currently supported load types in the user interface.
Spring supports are linear elastic with a stiffness that does not depend on the load, and they are rigid in the axial direction; there is no axial spring. Internal hinges are pure moment releases; shear or axial hinges, spring hinges, and prescribed support displacements are not included.
Nonlinear and dynamic effects
Large deformations and geometric nonlinearity, plastic behavior, vibration, impact and dynamic loads, and time- or temperature-dependent behavior are not considered.
Additional strength checks
SpanDraft does not check buckling, local buckling, lateral-torsional buckling, fatigue, or local effects at notches, holes, or connections.
Shear and equivalent stresses, complete combined-stress assessments, and code-based safety or resistance checks are also not included.
The basic bending assessment is explained under Bending stress and safety factor.
The bending axis remains two-dimensional
Selecting y-y, z-z, u-u, or v-v determines which cross-section properties are used for the single bending plane being analyzed.
It does not rotate the beam in three-dimensional space or create a three-dimensional decomposition of forces.
For more information, see Beam, material and cross-section.
The real component remains an idealization
SpanDraft uses idealized supports and loads and a constant cross-section.
A real component may include, for example, clearance, flexibility, holes, welds, or local reinforcements.
The important question is therefore not only whether the mathematical model can be solved, but whether its idealization represents the real situation adequately.
Technical background: Calculation model and assumptions.