Result diagrams and support reactions

SpanDraft displays the calculated deflection, shear force, and bending moment along the beam.

The horizontal axis represents the longitudinal beam coordinate x. Support reactions and selected key results are shown in the project overview.

Deflection w(x)

Deflection of the example beam with the extreme value marked at the center

w(x) describes the transverse displacement of the beam axis along the beam.

Positive and negative values correspond to the two directions of the defined w axis. A typical downward deflection therefore appears as a negative value.

It is often useful to know where the largest deflection occurs and how large its magnitude is. Extreme values are marked in the diagram.

The Maximum deflection value in the project overview shows the largest magnitude of the transverse displacement.

Shear force V(x)

Shear force of the example beam with positive and negative values and a jump at the centered point force

V(x) shows the internal shear force along the beam.

Point forces and vertical support reactions can produce visible jumps. Under a constant distributed load, the shear force changes continuously; under a linearly varying load its slope changes too, and its extremum lies where the load is zero.

Positive and negative values indicate different directions according to the sign convention used. The sign does not indicate whether a result is “good” or “bad.”

Bending moment M(x)

Bending moment of the example beam with the maximum marked at the center

M(x) shows the internal bending-moment distribution.

Large magnitudes indicate regions with high bending demand. Positive and negative values represent different bending directions.

Both directions are considered when calculating the maximum bending stress; the relevant moment magnitude governs.

Extreme values are marked in the diagram. An applied point moment can create a jump in the bending-moment diagram.

Support reactions

Support reactions are forces or moments through which the idealized supports balance the external loads in the calculated model.

Positive result Direction
Rx > 0 → to the right
Ry > 0 ↑ upward
Reaction moment > 0 ↺ counterclockwise

A negative result acts in the opposite direction.

SpanDraft displays only reaction components that the relevant support type can transmit.

Components that cannot be transmitted remain blank in the overview. A calculated reaction component whose value is zero is still displayed.

Key results in the project overview

Result Meaning
Maximum deflection largest magnitude of transverse displacement
Governing moment largest magnitude of the bending moment
Maximum bending stress elastic bending stress derived from the governing moment and section properties
Safety factor comparison with the stored material strength value

If no results are displayed, see Troubleshooting.